Limiting the dimension of a screw-access hole with an interim screw-retained prosthesis

Chandur Wadhwani; Kwok-Hung Chung

doi:10.1016/j.prosdent.2014.12.020

Limiting the dimension of a screw-access hole with an interim screw-retained prosthesis

J Prosthet Dent. 2015 Jun;113(6):648-50. doi: 10.1016/j.prosdent.2014.12.020. Epub 2015 Apr 7.

Authors

Chandur Wadhwani¹, Kwok-Hung Chung²

Affiliations

¹ Affiliate faculty, Department of Restorative Dentistry, University of Washington, Seattle, Wash; and Private practice, Bellevue, Wash. Electronic address: [email protected].
² Professor, Department of Restorative Dentistry, University of Washington, Seattle, Wash.

PMID: 25858223
DOI: 10.1016/j.prosdent.2014.12.020

Abstract

Fabricating an interim screw-retained prosthesis often involves obliteration of the abutment screw access site, which later must be exposed. This frequently results in excessive preparation of the screw access site with poor esthetics and a weaker restoration. The technique described expedites the process by locating the access site and limits the size of the screw access hole preparation.

MeSH terms

Crowns*
Dental Implant-Abutment Design*
Dental Implants
Dental Impression Materials / chemistry
Dental Impression Technique / instrumentation
Dental Prosthesis Design
Dental Prosthesis, Implant-Supported*
Dental Restoration, Temporary*
Humans
Models, Dental
Polyvinyls / chemistry
Siloxanes / chemistry

Substances

Dental Implants
Dental Impression Materials
Polyvinyls
Siloxanes
vinyl polysiloxane