Ultrashort-pulse laser as a surface treatment for bonding between zirconia and resin cement

Objectives: To evaluate ultrashort-pulse laser (UPL) as a surface treatment for improved bond strength to Yttria-tetragonal zirconia polycrystalline (Y-TZP).

Methods: Fully-sintered Y-TZP samples received either no treatment (CTL), or were treated by alumina blasting (ALB), tribochemical silica coating (SIL), or one of two UPL patterns: multiple pulses laser surface dots with 2.5μm spacing (8mJ, 10kHz)(LSD); or single pulse laser surface lines with 2.5μm spacing (4mJ, 6.7kHz)(LSL). Surface roughness, wettability (contact angle), and quantification of crystalline phases were evaluated for each group (n=3/group). Y-TZP treated slabs were cemented to resin composite slabs using silane and 10-methacryloyloxydecyl dihydrogen phosphate (MDP)-containing adhesive. Beams from the Y-TZP/resin blocks were microtensile tested (n=5/group) after 48h water incubation (37°C) with or without subsequent thermocycling (5-55°C, 5000 cycles).

Results: All surface treatments increased surface roughness values versus control (P<0.001). Contact angles were lowest for SIL (6.57±2.37°) and highest for control (50.97±6.30°). LSL and LSD were the only treatments that did not increase the relative monoclinic phase. All surface treatments significantly increased microtensile bond strengths (μTBS) compared with the control group (P<0.001), with highest values for UPL (LSD: 35.40±4.53MPa>LSL: 31.84±8.46MPa>SIL: 19.95±3.99MPa=ALB: 19.51±2.55MPa>CTL: 14.51±2.23MPa). Thermocycling significantly reduced bond strength for all treatments in a surface treatment-dependent manner.

Significance: The ability of UPL to alter Y-TZP surface morphology, increase wettability and μTBS without increasing the monoclinic content suggests its potential to improve bonding to the underlying resin cement and tooth without compromising the strength of the restoration.