Purpose: Three-dimensional (3D)-two-dimensional (2D) fluoroscopic image registration was used to measure 3D hip kinematics before and after hip arthroscopy in patients with femoroacetabular impingement (FAI).
Methods: In total, 24 subjects diagnosed with FAI (21 unilateral, 3 bilateral) were prospectively recruited. A clinical impingement test was performed on both hips while the patient was awake and then while anaesthetized, and in the operative hip after arthroscopic osteoplasties and labral repair. Fluoroscopy was used to image the hip during the impingement tests. Images were analyzed using 3D-2D image registration to calculate joint kinematics. The examiner's hand was instrumented with a glove to measure internal rotation torque applied to the hip during each test.
Results: Internal rotation increased by 3.7° (standard error [SE] 0.95°) after surgery (P = .001). Maximum displacement of the femoral head out of the acetabulum was 4.0 mm (SE 0.5 mm) in the operative group before surgery and 1.8 mm (SE 0.3 mm) after surgery (P < .001). This was due to a decrease in lateral displacement by 1.3 mm (SE 0.4 mm, P = .002) and proximal displacement by 0.8 mm (SE 0.3 mm, P = .013). Internal rotation torque was greater in the operative hips when anaesthetized compared with when awake, by 5 Nm (SE 1.2 Nm, P < .001), and greater in the contralateral hips than the operative hips when awake by 8.4 Nm (SE 1.4 mm, P < .001).
Conclusions: Arthroscopic osteoplasty and labral repair increased hip range of motion and reduced femoral head displacement from the acetabulum during the IR90 provocation test (i.e., hip flexion to 90°, maximum internal rotation) in patients with FAI. This suggests that the impinging acetabular rim acted as a fulcrum before surgery and may have caused edge loading that was reduced after surgery.
Level of evidence: Level IV case series, therapeutic study.
© 2022 Published by Elsevier Inc. on behalf of the Arthroscopy Association of North America.