High brightness and low operating voltage CsPbBr3 perovskite LEDs by single-source vapor deposition

Kuan-Chi Yeh; Chia-Hua Chan

doi:10.1038/s41598-024-54036-6

High brightness and low operating voltage CsPbBr₃ perovskite LEDs by single-source vapor deposition

Sci Rep. 2024 Feb 9;14(1):3351. doi: 10.1038/s41598-024-54036-6.

Authors

Kuan-Chi Yeh¹, Chia-Hua Chan²

Affiliations

¹ Graduate Institute of Energy Engineering, National Central University, No. 300, Zhongda Rd., Zhongli Dist., Taoyuan City, 32001, Taiwan, ROC.
² Graduate Institute of Energy Engineering, National Central University, No. 300, Zhongda Rd., Zhongli Dist., Taoyuan City, 32001, Taiwan, ROC. [email protected].

Abstract

In this work, we utilized CsPbBr₃ powder as the precursor material for the single-source vapor deposition (SSVD) process to fabricate the CsPbBr₃ emitting layer. Due to the high density of grain boundaries and defects in the thin films deposited in the initial stages, non-radiative recombination can occur, reducing the efficiency of perovskite light-emitting diodes (PeLED). To address this issue, we employed a thermal annealing process by subjecting the perovskite films to the appropriate annealing temperature, facilitating the coalescence and growth of different grains, improving lattice integrity, and thereby reducing the presence of defects and enhancing the photoluminescence performance of the films. Furthermore, in this study, we successfully fabricated simple-structured CsPbBr₃ PeLED using thermally annealed CsPbBr₃ films. Among these components, even without adding the electron and hole transport layers, the best-performing device achieved a maximum brightness of 14,079 cd/m² at a driving voltage of only 2.92 V after annealing at 350 °C; the brightness is 16.8 times higher than that of CsPbBr₃ PeLED without heat treatment, demonstrating outstanding light-emitting performance. The research results show that using SSVD to prepare CsPbBr₃ PeLED has broad application potential, providing a simple process option for research on improving the performance of PeLED.