The angiotensin I-based peptide Asp-Arg-Val-Tyr-Ile-His-Pro-Phe-His-Leu-Leu-Glu-Glu-Ser yields angiotensin I (Ang I) and Leu-Glu-Glu-Ser upon hydrolysis by the human immunodeficiency virus type 1 (HIV-1) protease, but not by human renin. N-terminal sequencing of the reaction products showed that the HIV-1 protease cleaved exclusively at the Leu-Leu bond. The rate of Ang I formation can be measured by a radioimmunoassay, since the parent peptide has minimal cross reactivity in this assay. The rate of enzymatic hydrolysis is maximal at pH 4.5-5.0 and at an ionic strength of 1 M. At 37 degrees C, 0.1 M Na acetate buffer, pH 5.0, 1 M NaCl, 10% glycerol, 5% ethylene glycol, 1 mg/ml bovine serum albumin, and 3 mM EDTA, the reaction obeys Michaelis-Menten type kinetics with Km = 17.2 +/- 3.5 microM and kcat = 2.30 +/- 0.33 min-1. The activity assay readily quantitates as little as 0.25 nM of HIV-1 protease. The production of Ang I by the HIV-1 protease is inhibited in the presence of a HIV-1 protease inhibitor. The newly discovered substrate is relatively insensitive to human or monkey serum. Therefore, the effect of sera from 20 patients with advanced acquired immunodeficiency disease syndrome (AIDS) on Ang I production in the above assay system was examined. Results of this study indicate that it may be possible to adapt the above Ang I-based system to determine blood levels of HIV-1 protease inhibitors in AIDS patients during clinical trials.