Objective: To determine surface roughness caused by Er:YAG laser irradiation and its effect on the increase in bacterial adhesion. Background: Er:YAG laser was proposed as a strategic device to reduce caries by its ability to generate chemical and structural changes in tooth enamel; in turn, it produces undesirable effects on the tooth surface that could increase its roughness and allow a greater accumulation of microorganisms. Methods: Eighty-four samples of human enamel were divided into seven groups (n = 12): G1_control (no laser irradiation); G2_100/H2O, G3_200/H2O, and G4_300/H2O were irradiated with Er:YAG laser (12.7, 25.5, and 38.2 J/cm2, respectively) under water irrigation. In addition, G5_100, G6_200, and G7_300 were irradiated with the energy densities described above and no water irrigation. Surface roughness measurements were recorded before and after treatment using a profilometer. Afterward, three samples per group were incubated in a microorganism suspension for the tetrazolium salt (XTT) assay. Biofilm morphology was observed using scanning electron microscopy and confocal laser scanning microscope. One-way analysis of variance and t-tests were performed for statistical analysis (p < 0.05). Results: There were no statistically significant differences in roughness values in the G5_100 group before and after treatment, but there were statistically significant differences observed in the other groups evaluated (p < 0.05). No significant differences in adhesion of both strains were detected in irradiated groups compared with G1_control. Conclusions: The increase in roughness on dental enamel surfaces was proportional to the irradiation conditions. However, the increase in surface roughness caused by Er:YAG laser irradiation did not affect Streptococcus mutans and S. sanguinis adhesion.
Keywords: colonization; dental caries; microorganisms; microscopy; preventive dentistry; pulsed lasers.