The risk of tooth root injuries using cortical screws for intermaxillary fixation and osteosynthesis plates - A retrospective analysis

Intermaxillary fixation (IMF) and osteosynthesis plates (OP) are widely used for the non-surgical and surgical treatment of mandible and condyle fractures. The aim of this retrospective study was to analyze the frequency of tooth root injuries by IMF and OP screws. Electronic patient reports (2004-2013) were screened for patients treated with either IMF screws and/or OP in the Department of Oral- and Maxillofacial Surgery, University Medical Center Mainz, Germany. The frequency and the position of endangered and injured teeth were analyzed by orthopantomogram (OPTG) and cone beam computer tomography (CBCT). Next, possible predictive factors for tooth root injuries, namely interdental- and crestal distance, screw length and distance between tooth root and screw were evaluated. Further, the accuracy of OPTG vs. CBCT concerning the diagnosis of tooth root injuries was analyzed. Three-hundred sixty-six patients were included and 3388 teeth were defined as endangered by IMF- and OP screws. Overall, 16 injured teeth (0.5%) in 13 patients (3.55%) were detected. Nine injuries (56.3%) were caused by IMF- and seven injuries (43.8%) by OP screws. Three teeth were non-vital, one tooth had to be extracted. No correlation between the predictive factors crestal distance, screw length and tooth root injuries was found. If tooth injury occurred, a significant correlation between the interdental distance and the distance between tooth root and screw was found (κ = 0.48; p < 0,0001). Comparison between OPTG vs. CBCT demonstrated that many of the injuries that were seen in the OPTG (n = 230) could not be verified in the CBCT scans (n = 16) (κ = 0.12). To conclude, screws for IMF and OP can be considered as a safe procedure concerning the risk of tooth root injuries.