This work presents the preparation of a series of [(PbSe)1+δ]4[TiSe2]4 isomers via a low temperature synthesis approach that exploits precursor nanoarchitecture to direct formation of specific isomers. The targeted isomers formed even when the precursors did not have the correct amount of each element to make a unit cell from each repeating sequence of elemental layers deposited. This suggests that the exact composition of the precursors is less important than the nanoarchitecture in directing the formation of the compounds. The as-deposited diffraction data show that the isomers begin to form during the deposition, and Ti2Se, in addition to PbSe and TiSe2, are present in the specular diffraction patterns. HAADF-STEM images reveal impurity layers above and below an integer number of targeted isomer unit cells. The structural data suggest that Ti2Se forms as Se is deposited on the initial Ti layers and remains throughout isomer self-assembly. During growth, the isomers deplete the local supply of Ti and Pb, creating diffusion gradients that drive additional cations toward the growth front, which leaves surface impurity layers of TiSe2 and TiO2 after the supply of Pb is exhausted. The deposited stacking sequences direct formation of the targeted isomers, but fewer repeating units form than intended due to the lack of material per layer in the precursor and formation of impurity layers. All isomers have negative Hall and Seebeck coefficients, indicating that electrons are the majority carrier. The carrier concentration and conductivity of the isomers increase with the number of interfaces in the unit cell, resulting from charge donation between adjacent layers. The opposite variation of the carrier concentration and mobility with temperature result in minima in the resistivity between 50 and 100 K. The very weak temperature dependence of the carrier concentration likely results from changes in the amount of charge transfer between the layers with temperature.