Objective: This pilot study evaluated the impact of using a 3D printed model of the patient's bronchovascular lung anatomy on the mental workload and fatigue of surgeons during full thoracoscopic segmentectomy.
Design: We performed a feasibility pilot study of a prospective randomized controlled trial with 2 parallel arms. All included patients underwent digital 3D visual reconstruction of their bronchovascular anatomy and were randomized into the following two groups: Digital arm (only a virtual 3D model was available) and Digital + Object arm (both virtual and printed 3D models were available). The primary end-point was the surgeons' mental workload measured using the National Aeronautics and Space Administration-Task Load Index (NASA-TLX) score.
Setting: Between October 28, 2020 and October 05, 2021, we successively investigated all anatomic segmentectomies performed via thoracoscopy in the Thoracic Department of the Montsouris Mutualiste Institute, except for S6 segmentectomies and S4+5 left bi-segmentectomies.
Participants: We assessed 102 patients for anatomical segmentectomy. Among the, 40 were randomly assigned, and 34 were deemed analysable, with 17 patients included in each arm.
Results: Comparison of the two groups, each comprising 17 patients, revealed no statistically significant difference in primary or secondary end-points. The consultation of the visual digital model was significantly less frequent when a 3D printed model was available (6 versus 54 consultations, p = 0.001). Notably, both arms exhibited high NASA-TLX scores, particularly in terms of mental demand, temporal demand, and effort scores.
Conclusion: In our pilot study, 3D printed models and digital 3D reconstructions for pre-operative planning had an equivalent effect on thoracoscopic anatomic segmentectomy for experienced surgeons. The originality of this study lies in its focus on the impact of 3D printing of bronchovascular anatomy on surgeons, rather than solely on the surgical procedure.
© 2024 The Authors.