Intelligent Process Monitoring of Smart Polymer Composites Using Large Area Graphene Coated Fabric Sensor

The location of defect formed in the final composite is identified using sensor data. Herein, we report the development of an online process monitoring system for vacuum-assisted resin transfer molding (VARTM) process using large area graphene coated in-situ fabric sensor. Besides imparting excellent mechanical properties to the final composites, these sensors provide critical information during the composite processing including detecting defects and evaluating processing parameters. The obtained information can be used to create a digital passport of the manufacturing phase to develop a cost-effective production technique and fabricate high-quality composites. The fabric sensor was produced using a scalable dip-coating process by coating 1-, 3- or 5-layers of thermally reduced graphene oxide (rGO) onto glass fabric surface according to the number of dips of the fabrics into GO solution. 5 electrode pairs were placed in the horizontal and vertical directions on the area of each coated fabric sensor before placing it inside the VARTM setup. The electrical resistances from all electrode pairs were simultaneously and continuously recorded during distinct stages of the VARTM process to determine the relative conductance. During the vacuum cycle, the range of relative conductance increased with the number of coated rGO layers, with the 5-layer rGO-coated sensor showing the highest conductance range of 16.9 %. Additionally, it was observed that the 5-layer coated sensor showed a consistent decrease in conductance during the infusion phase due to the fluid flow pressure dominating the resin electrical conductivity. Most importantly, physical parameters such as infusion time, flow front location, race-tracking and dry spots were monitored in-situ.