This study has been carried out to analyze the influence of the design of three geometric elements (wall thickness, platform width, and chamfer) of Ti-base abutments on the distribution of stresses and strains on the implant, the retention screw, the Ti base, and the bone. This study was carried out using FEA, analyzing eight different Ti-base models based on combinations of the geometric factors under study. The model was adapted to the standard Dynamic Loading Test For Endosseous Dental Implants. A force of 360 N with a direction of 30° was simulated and the maximum load values were calculated for each model, which are related to a result higher than the proportional elastic limit of the implant. The transferred stresses according to von Mises and microdeformations were measured for all the alloplastic elements and the simulated support bone, respectively. These results were validated with a static load test using a creep testing machine. The results show that the design factors involved with the most appropriate stress distribution are the chamfer, a thick wall, and a narrow platform. A greater thickness (0.4 mm) is also related to lower stress values according to von Mises at the level of the retaining screws. In general, the distributions of tension at the implants and microdeformation at the level of the cortical and trabecular bone are similar in all study models. The in vitro study on a Ti-base control model determined that the maximum load before the mechanical failure of the implant is 360 N, in accordance with the results obtained for all the Ti-base designs analyzed in the FEA. The results of this FEA study show that modifications to the Ti-base design influence the biomechanical behavior and, ultimately, the way in which tension is transferred to the entire prosthesis-implant-bone system.
Keywords: Ti base; abutments; dental implants; finite element analysis; strain distribution; stress distribution.