Microplastics in urban water cycles: Looking for a more scientific approach for sampling and characterization in wastewater and drinking water treatment plants

Specific campaigns to detect microplastics (MPs) in the urban water cycle were carried out in three drinking water plants and two wastewater treatment plants. A self-designed sampler for MPs detection in water matrices was in this study preliminary validated and then tested in long term campaigns sampling up to 1000 L. Raw drinking water and wastewater show microplastics (MPs) concentrations of 2-11 and of 480-801 MPs/m³, respectively, and MPs removals of 47-78 % and of 84-98 %, correspondingly. Specific roles of chemical and physical conventional processes in microplastics removals were investigated. Solid-liquid separation, flotation and filtration are the main processes for achieving high microplastics removal. Regarding concentrated matrices, MPs concentrations in sludge samples varied in the range of 5000-500,000 MPs/m³. Finally, shapes, size classes and polymers' typologies were investigated in the extracted MPs. The detected sizes are mainly 0.5-0.1 mm in drinking waters while 5-1 mm in wastewaters. Wastewaters were predominated by synthetic fibers (polyester type), while drinking waters were mainly characterized by fragments and the fibers were mostly of natural origin. Finally, the results of this study supported best practices and guidelines for a representative assessment of MPs in water (sampling methods, extraction procedures, characterization and quantification).