Template:CRL-tlj-forearms
From 501st Legion Databank
|
Forearms
- Forearms shall have ridged rail, similar to a Picatinny, embedded on the inside of the forearm, roughly covered 1/3rd by a box shape.
- Forearms shall have a box on the bottom of the wrist end. Each box shall have a single black square in the lower inside corner.
- Each forearm shall have two 'clasp greeblies' on the outside facing surface, near the wrist.
- Detail box includes black rectangle on small edge perpendicular and closest to the wrist.
|
OPTIONAL Level two certification (if applicable):
- The boxes should sit against the forearm with minimal gap.
- On the ridged rail the third retaining button head closest to the elbow is to be painted grey or is a grey decal.
|
OPTIONAL Level three certification (if applicable):
- The seam between the forearm boxes and the forearm should not be filled.
- The top (elbow end) of the forearm should be trimmed in the correct TLJ/TroS shape. TFA cut is not permitted.
- On the ridged rail the third retaining button head closest to the elbow is an Allen key dome Hex bolt, approximately 5mm head width. Decals or paint are not permissible.
|
|