- "Traffic counter" redirects here. For traffic counting in computer networks, see Network traffic measurement.
A traffic count is a count of traffic along a particular road, either done electronically or by people counting by the side of the road.[1] Traffic counts can be used by local councils to identify which routes are used most, and to either improve that road or provide an alternative if there is an excessive amount of traffic. Also, some geography fieldwork involves a traffic count. They are useful for comparing two or more roads, and also can be used alongside other methods to find out where the CBD of a settlement is located.
Counting methods
To permanently monitor the usage of a road, an electronic traffic counter can be installed as a way of measuring road usage. In other places people either draw up a table and use a tally to keep a record of vehicles which pass. This data can then be used to convince a local council that a particular road needs to have more work done on it or an alternative route needs to be built.
Example Table from a Traffic Count
This is an example of a traffic count, showing the type of vehicle and the data collected at a particular place in each direction. As you can see, this data has been compiled into numbers from each direction and a total count. The original table (which was used out on the road) used data recorded in tally form.
| Vehicle Type | Direction X | Direction Y | Total |
|---|---|---|---|
| Car | 48 | 47 | 95 |
| Lorry | 2 | 0 | 2 |
| Van | 5 | 7 | 12 |
| Bus | 1 | 0 | 1 |
| Bike | 3 | 1 | 4 |
| Pedestrian | 3 | 4 | 7 |
Traffic counter device
A traffic counter is a device, often electronic in nature, used to count, classify, and/or, measure the speed of vehicular traffic passing along a given roadway. The device is usually deployed in near proximity to the roadway and uses an intrusive medium, such as pneumatic road tubes laid across the roadway, piezo-electric sensors embedded in the roadway, inductive loops cut into the roadway, or a combination of these to detect the passing vehicles. Recently, in the interest of worker safety and ease of installation, non-intrusive technologies have been developed.[2] These devices generally use some sort of transmitted energy such as radar waves or infrared beams to detect vehicles passing over the roadway.
See also
References
- ^ FHWA Traffic Monitoring Guide TMG - Traffic Monitoring Guide. April 2008. Retrieved July 2010
- ^ "Field Test of Monitoring of Urban Vehicle Operations Using Non-Intrusive Technologies". Federal Highway Administration. 1997. Retrieved 2006-06-20.
{{cite web}}: Unknown parameter|month=ignored (help)