Name Plate WEG-w22 PDF
Name Plate WEG-w22 PDF
net
3.8 Endshields
The drive end endshield (figure 15) is designed with fins for
better thermal heat dissipation, and to ensure low bearing
operating temperatures, resulting in extended lubrication
intervals.
For the frames 225S/M to 355A/B, where ventilation is critical
for thermal performance of the motor, the endshield fastening
screws are placed in such a way so as not to block airflow to
any fin, thus contributing to better thermal exchange.
3.11 Nameplate
The nameplate supplies information determining motor
construction and performance characteristics. The line name
is given on the first line of the nameplate together with
nominal efficiency levels as required by IEC 60034-30-1.
3.9 Drains
The endshields have holes for drainage of water that may
condense inside of the frame. These holes are supplied with
rubber drain plugs, in accordance with figure 16. These plugs
leave the factory in the closed position and must be opened
periodically to allow the exit of condensed water.
1
25 26
6 7 8 12 9 4 04AGO14 0000000000
2 16 15
3 10 13 14 27
5
11
19
20
21
22
17
18
24
3.10 Fan Cover 25 26
The fan cover is made of steel for frames 63 to 132 and 6 7 8 12 9 04AGO14 0000000000
2 4 16 15
FC-200 (EN GJL 200) cast iron for frames 160 to 355. The 3 10 13 14 27
cast iron fan covers have an aerodynamic design, which 5