CI BA4558 Datasheet
CI BA4558 Datasheet
CI BA4558 Datasheet
The BA4558, BA4558F, and BA4558N are monolithic ICs with two operational amplifiers featuring low power con-
sumption and internal phase compensation mounted on a single silicon chip. These products offer high speed, a
wide band width, and low noise.
Outstanding thermal characteristics and voltage gain band width make these ICs ideal for use in a wide variety of
electronic circuits. The BA4558 comes in an 8-pin DIP package and is compatible with the 4558 operational amplifi-
er. The BA4558F comes in an 8-pin SOP package, and the BA4558N in an 8-pin SIP package.
•Active
Applications
filters
Audio amplifiers
VCOs
Other electronic circuits
•1)Features
Low power dissipation of approximately 50mW 4) No latch-up.
(typ.). 5) Wide range of common mode and differential volt-
2) Built-in output short-circuit protection circuit. age.
3) Internal phase compensation. 6) High gain and low noise.
•Block diagram
BA4558 / BA4558F BA4558N
OUT1 1 8 VCC
+ +
1ch 2ch
– IN1 2 7 OUT2 – –
1ch
– +
2ch
+ IN1 3 + – 6 – IN2
1
8
OUT1
– IN1
+ IN1
VEE
+ IN2
– IN2
OUT2
VCC
VEE 4 5 + IN2
1
Standard ICs BA4558 / BA4558F / BA4558N
R1
Q7
Q5 Q13
Q11
Q8
R6 Q15
– IN Q1 Q2 Q9
R7 R8
R5
+ IN
Q12 Q14
Q6 OUT
Q3 Q4 Q10
R9 D
R2 R3 R4
VEE
2
Standard ICs BA4558 / BA4558F / BA4558N
1000
QUIESCENT CURRENT: IQ (mA)
100
POWER DISSIPATION: Pd (mW)
BA4558N
BA4558F
400 3 40
200 20
0 2 0
0 25 50 75 85 100 125 150 0 ± 10 ± 20 1 10 100 1k 10k 100k 1M 10M
Fig.1 Power dissipation vs. ambient Fig.2 Quiescent current vs. power Fig.3 Open loop voltage gain vs.
temperature supply voltage frequency
32 100 100
MAXIMUM OUTPUT VOLTAGE: VOM (V)
28
INPUT BIAS CURRENT: IB (mA)
24
80 75
20
16
12
60 50
8
0 40 25
100 1k 10k 100k 1M – 20 0 20 40 60 80 0 10 20 30 40
FREQUENCY: f (Hz) AMBIENT TEMPERATURE: Ta (°C) POWER SUPPLY VOLTAGE: V+ (V)
Fig.4 Maximum output voltage vs. Fig.5 Input bias current vs. ambient Fig.6 Input bias current vs. power
frequency temperature supply voltage
3
Standard ICs BA4558 / BA4558F / BA4558N
20
+5
0 10
VOUT (V)
–5
0 – 10
VIN (V)
–5
– 20
0 20 40 60 80 0 ± 10 ± 20
TIME (µs) POWER SUPPLY VOLTAGE: V± (V)
Fig.7 Output response characteristics Fig.8 Common mode input voltage vs.
power supply voltage
VCC
•(1)Operation notes
Unused circuit connections
If there are any circuits which are not being used, we
–
recommend making connections as shown in Figure 9,
with the non-inverted input pin connected to the poten- To potential +
in VICM
tial within the in-phase input voltage range (VICM).
VEE
4
Standard ICs BA4558 / BA4558F / BA4558N
9.3 ± 0.3
5.0 ± 0.2
8 5
6.5 ± 0.3
8 5
6.2 ± 0.3
4.4 ± 0.2
1 4
0.51Min.
7.62
0.15 ± 0.1
3.2 ± 0.2 3.4 ± 0.3
1 4
1.5 ± 0.1
0.3 ± 0.1
0.11
2.54 0.5 ± 0.1 0° ~ 15° 1.27 0.4 ± 0.1 0.3Min.
0.15
DIP8 SOP8
BA4558N
1.2
1 8
3.5 ± 0.5
1.3
SIP8