Modules

On the Subject of Wires

We couldn’t make a bomb defusal game without adding wires. Like,
seriously.

There can be 3-5 wires on a wire module.

Only one wire must be cut to disarm the module.

The more wires present, the more complicated it gets. However

this module is considered as an easy module.

All wires from first to last position are identified from top to bottom.

3 wires:
● If there are no red wires, cut the first wire.
● If there is a white wire, cut the second wire.
● If there is a blue wire, cut the last wire.

4 wires:
● If there are no green wires, cut the first wire.
● Otherwise, if there are no blue wires, cut the second wire.
● Otherwise, if there are no white wires, cut the third wire.
● If none of the above apply, cut the last wire.

5 wires:
● If the color of the light above the module is red, cut the first wire.
● Otherwise, if the light is green, cut the second wire.
● Otherwise, if the light is blue, cut the third wire.
● Otherwise, if the light is yellow, cut the fourth wire.
● If none of the above apply, cut the last wire.

Module Difficulty: Easy

Modules

Wires
On the Subject of the Button
That big suspicious button is 100% safe!

The color and text on the button can vary.

The button must be pushed a certain number of times before

moving on to Step 2.

1. If the button is blue and it says ‘Detonate’, click the button.

2. If the button is red, click the button twice.
3. If the button says ‘Abort’, click the button 3 times.
4. If the button is grey or white, click the button 4 times.

After completing the above, refer to Step 2 below.

Step 2:

1. If the button was clicked twice or less, press down arrow.

2. If not, press up arrow.

Module Difficulty: Easy Button

Modules

On the Subject of H e xadecimal

Just a few letters and numbers. And a bomb. Whatever.

There is a display showing four pairs of two characters.

Each pair of characters must be translated into a single lowercase

letter.

The letters must not be separated before submitting your answer.

This is an easy module.

Refer to the table below to translate the pairs of characters.

61 Hex 6E
62 6F
a n
63 70
b o
64 71
c p
65 72
d q r
66 73
e s t
67 Table 74
f g u
68 75
h i v
69 76
j k w
6A 77
l x
6B 78
m y z
6C 79
6D 7A
Modules

Module Difficulty: Easy

Hexadecimal
On the Subject of Keypads
This module eliminates anyone who can’t do
simple algebra.

There are four buttons with a number label on

each one.

All four buttons must be pressed in the correct

order to disarm this module. Pressing them in
the wrong order will strike you.

This is a hard module.

Go through each button one by one to get your first answer.

Please take note of the number referred to as X.

Button 1:
● If the button’s label is under 10, X is 15.

● Otherwise, if the label is between 10 and 20, X is 20. ● Otherwise, if the label

is between 20 and 80, X is 30. ● If none of the above apply, X is 10.

Button 2:
● If the label is under 10, add 10 to X.

● Otherwise, if the label is between 10 and 20, double X.

● Otherwise, if the label is between 20 and 80, triple X.

● If none of the above apply, subtract 10 from X.

Modules

Button 3:
● If the label is under 10, double X.

● Otherwise, if the label is between 10 and 20, triple X.

● Otherwise, if the label is between 20 and 80, subtract 5 from X.

● If none of the above apply, leave X the same and move on to the next step.

Button 4:
● If the label is under 10, double X.

● Otherwise, if the label is between 10 and 20, add 20 to X. ● Otherwise, if the

label is between 20 and 80, add 50 to X.

● If none of the above apply, triple X.

Now write down X as you will use it soon.

Attention!
● Before concluding, take all the label values written down on the keypad buttons and
add them up. This value is Y.

● Divide Y by 2.

● Subtract Y from X. (X-Y) The answer is Z.

Now follow the rules below in order to see which order to press the buttons. The
numbers on the pictures below refer to the order you press the buttons.
Modules
Modules

On the Subject of
Binary
If 0s and 1s make up all code, then why shouldn’t they make up this
module?

There are 7 strips of either lit or unlit indicators.

(Excluding the horizontal light on the top)

Decipher them in order to know how many times the red

button must be clicked before clicking the green button to submit.

Lit indicators are called 1s, unlit indicators are called 0s.

Read the following rules ONE BY ONE from TOP TO BOTTOM and follow the first one which fits.

This is a medium module.

1. If there are no lit indicators , click red once.

2. If light 2 is a 1 and light 7 is a 0, click red twice.

3. If light 1 and 2 are both 1s , click red three times.

4. If light 1 is a 0 and light 7 is a 0, click red four times.

5. If lights 1, 2 and 3 are 1s , click red five times.

6. If lights 1, 2, 3 and 4 are 1s, click red six times.

7. If more than 3 lights are off, click red seven times.

8. If more than 5 lights are on, click red eight times. 9. If all the

indicators are on , click red nine times.

-If none of the above apply , click red ten times.

Modules

Module Difficulty: Medium

Binary
On the Subject of Mathematics
Please, take out a calculator. Like, seriously.

The display shows two pairs of capital letters.

These letters each correspond to a single digit in a two digit

number.

Decipher both pairs of numbers and multiply th e m together to get the answer.

This is an easy module.

Use the table below to translate the letters into numbers.

A B C D E F G H I J
1 3 7 2 4 5 6 0 8 9

To translate, think of one letter as one digit.

Eg. Since ‘A’ is 1, then AA would be the number 11.

Modules

After translating both pairs of letters into

numbers, multiply both of them together. Then write the answer in the

answer box and press the submit button .

If the light on the right side turns red, the answer is incorrect.

If the light on the right side turns green, you have successfully disarmed the module.

Module Difficulty: Easy

Mathematics
On the Subject of Color Code
A bit tricky unless you know what you’re doing..

The display shows a string of 5 letters.

Each letter corresponds to a color’s initial.

Each color corresponds to a single number.

Press the red button the suitable amount of times before pressing the green button to
submit and disarm the module.

Below are the numbers corresponding to the light colors.

Red Green Blue Yellow White

0 0 1 2 3

Below are the numbers corresponding to the display letters.

Modules

G B Y W
R
1 3 2 3 4

● Add up the numbers you get for display letters. The answer is X. ● Add up the

numbers you get for light colors. The answer is Y.

X minus Y is the amount of times the red button must be clicked.

Attention!
If the end number is 0, just submit without clicking the red button. If the end number is
a negative number, submit without clicking the red button.

Module Difficulty: Medium

Color Code
On the Subject of Multi Buttons
Woah, colours.

The display shows a random string of 6

numbers.

Click every single button once in the correct

order to disarm the module.

Go through each of the following rules to see which button to

press first in each column.

Column 1:
● If the 1st number is under 6, click red.
Modules

● If not, click orange.

Column 2:
● If the 2nd number is under 6, click yellow.

● If not, click green.

Column 3:
● If the 3rd number is under 6, click blue.

● If not, click purple.

Follow the next few steps to see which order the remaining 3 buttons in each column

must be pressed. Follow the written order.

● If the 4th number is under 7, click the remaining buttons in first the 2nd, 3rd,

then 1st column.

● If the 5th number is under 7, click the remaining buttons in first the 3rd, 2nd,
then 1st column.
● If the 6th number is over 5, click all of the remaining buttons from left to right.
● If none apply, click the remaining buttons in the 1st, 3rd then 2nd column.

Module Difficulty: Medium

Multi Buttons
Keep reading to find when the button should be pressed.
Modules

● Add the first digit of the pair of numbers to the second. This value is X.
● Translate the pair of letters into numbers using the table below.

A B C D
4 3 7 9

● After translating, add both the digits of the second pair together. This value is Y.
● Multiply X by Y to get Z.
● Z matches a colour. Refer to the table to find the correct color. (Z top row, Color
bottom row) (The dash symbol means “to”)

0-59 60-99 100-199 200-299 300-399 400-499 500-599 600+

White Red Yellow Green Blue Yellow Red White

Module Difficulty: Medium

Timing
Modules

Needy modules can only be disarmed temporarily, and will reactivate

after a random amount of time. They beep when they are activated.

Needy Difficulty: Easy

Echo

Needy modules can only be disarmed temporarily, and will reactivate after a random
amount of time. They beep when they are activated.
Modules

Needy Difficulty: Easy

Counting
On the Subject of Tiles
Hold on, this module kinda looks like a face.

There are 2 tiles both randomly colored.

Enter the correct answer into the t e xt box and

press submit to disarm the module.

The following will explain how to get the correct answer.

● Every color corresponds to a number .

● Convert both tile colors into numbers using the table below.

Red Green Blue Yellow Pink White

1 9 7 2 6 5

● After converting, add both numbers together. ( Eg. 2+2=4)

● Enter the answer into the text box under the tiles.
● Press the button labelled “Submit”.

Upon pressing the submit button, the light above the two tiles will turn either red or
green.

If the light is green, the module has been successfully disarmed.

If the light is red, the answer in the text box is incorrect. Redo the module to try to get
the correct answer.
Modules

Module Difficulty: Easy

Tiles
Modules
 Modules

Use the table below to get which button you should press to disarm the module.

Refer to the serial number on the bomb for the following table. Read the table from
left to right and click the corresponding button if the condition is met.
The serial number is a string of 6 characters and can be found on the edges of the
bomb. It is most commonly found on the top.

If Serial letter A number letter D number letter I number

Number has a: 6 8 1

Then click: Yellow Blue Blue Blue Yellow Yellow

If none of the above apply, click Blue.

Module Difficulty: Extreme

Morse Code

Needy Module: Interview

Where’s your suit!?

The topmost display will ask you a question. Type the answer
in the text box below and press the green button to submit.

Needy modules can only be disarmed temporarily, and will

reactivate after a random amount of time. They beep when they
are activated.
Modules

Needy Difficulty: Easy

Interview